Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0121
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box.
160630
Mounting Strap (A)
Green Grounding
Screw (C)
Fixture Mounting
Screw(E)
Ball Nut(G)
Mounting Screw (B)
Wire Nut (D)
Lock Nut (F)
1. Attach the mounting strap to the outlet box by using
two mounting screws.
2. Screw the threaded pipe with hex nut end into the coupling,
and tighten it with the washer and hex nut.
NOTE:Depth of threaded pipe may need to be adjusted
to properly fit glass shade, decorative cover and small
pine cone.
4. Install bulbs (not included). See relamping label at socket
area or packaging for maximum allowed wattage.
5. Attach the glass shade to the fixture by inserting the threaded
pipe,and then secure it with a rubber pad, metal pad
and hex
nut.
6. Slip the decorative cover up through the threaded pipe, and then
secure it with the pine cone.
7. Pull out the source wires from the outlet box, make wire
connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from
the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
---Attach the fixture grounding wire (usually green
insulation or bare wire) to the mounting strap with
the green grounding screw,and then connect it to the
house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
Installation Steps
Washer (H)
Hex Nut (I)
Rubber Pad (K)
Metal Pad (L)
Threaded pipe (J)
Outlet Box
House Grounding Wire
Wire Nut (D)
Fixture Mounting Screw (E)
Mounting Strap (A)
Green Grounding Screw (C)
Canopy
Main Body
Socket
Pine Needle (O)
Coupling
Washer (H)
Hex Nut (I)
Small Pine Cone (P)
Threaded Pipe (J)
Glass Shade
Rubber Pad (K)
Metal Pad (L)
Hex Nut (I)
Decorative Cover (M)
Pine Cone (N)
Mounting Screw (B)
Lock nut (F)
Ball Nut (G)
Decorative Cover (M)
Pine Cone (N)1pc
Small Pine Cone (P)6pcs
Pine Needle (O)6pcs
Bulb Type A Max.60W
(not included)
3. Secure the small pine cones and the pine needles onto the main
body as shown in the diagram.