Installation Sheet
190325
Page 2 / 4
2. Place the plastic clips apart and mark with a pencil. Marks
should be :
6” apart for X0069 & X0070;
13.5” apart for X0071 & X0072;
18.5” apart for X0073 & X0074;
Plastic clips should be in line with each other. (See Fig. 2)
3. Secure the plastic clips to the mounting surface with the dry
wall screws provided. Make sure the ear’s side of plastic clip
facing outside. (See Fig. 2)
4.Attach the light fixture into the plastic clips and press the light
fixture to allow the ears of the plastic clips to hold the light fixture.
(See Fig.3)
5.Connect sensor with the light fixture by one linking cord.Then
connect the female connector with the other linking cord and the
male plug of the adaptor. And plug the adaptor into the outlet.
(See Fig.4 )
Fig.2.
Fig.3.
Ear
Plastic clip
Ear
Guide slot
Plastic clip
Dry Wall Screw
Light fixture
Light fixture
Outlet
Female Connector
Sensor
Linking cord
Linking cord
Male Plug
Adaptor
Fig.4
Turn on the power at fuse or circuit box.
The cabinet lighting fixture units can be connected by using I-joiner or by using linking cord (12 inches).
Note: Maximum number of cabinet light fixtures per run should not exceed power supply wattage rating.
Fig.5
Using I-Joiner:
1. Align connector on end of new fixture with connector on end of existing fixture.
2. Push new fixture to existing fixture until fixtures are flush and connectors snap together by using I-Joiner. (See Fig.5)
Using 12˝ linking cord:
Determine location for next fixture in run. (Minimum 3” distance for linking cord should be allowed at both ends of fixtures).
Install the additional cabinet light fixture by following steps 2-4 of the instruction steps. Once installed, attach the linking
cord (12 inches) between the last cabinet light fixture and the new one. (See Fig.5)
Make sure the distance between cabinet lighting fixtures does not exceed the linking cord length.
Outlet
Male plug
Female Connector
Sensor
Male plug
Linking cord
I-Joiner
Adaptor
Connecting fixture to fixture:
Power Label: This hardware package has a label.
Please paste the label on the cabinet,
in order to remind the position of the
ON/OFF switch.