Installation Sheet

12” Linking Cord

Plastic Clip

Dry Wall Screw

190325

I-Joiner

Page 1 / 4

Important to Know

1. Read all instructions carefully before installation and operation.

If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified electrician.

3. Do not use in wet locations, use indoors only.

4. Non-replaceable LEDs.

5. Specification:

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

X0069 / X0070 / X0071 / X0072 / X0073 / X0074

NO.

Dimension(inch)

Total

Watts

Item #:

X0069/X0070

X0071/X0072

X0073/X0074

0.4

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Included:

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Installation Steps

Find a suitable location to mount the fixture, make sure that the adapter will reach the nearest electrical outlet with the

provided power cord. The mounting surface should be minimum of 1/2 inch. thick.

Note: The recommended location for the under cabinet light fixture is near the front lip of the cabinet. This provides the

best light distribution across the countertop.

Fig.1.

Adhesive Strip

Sensor

Plastic Cap

1. Gently open the plastic cap from the sensor by a small flat-head

driver and peal off the adhesive strip from the back of the sensor.

Then place the sensor on the suitable location and tighten it onto

the mounting surface with the mounting screw. (See Fig.1)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS X0069 / X0070 / X0071 / X0072 / X0073 / X0074 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Included: I-Joiner Dry Wall Screw 12” Linking Cord Plastic Clip Important to Know 1. Read all instructions carefully before installation and operation. 2.
PAGE 2
. Place the plastic clips apart and mark with a pencil. Marks should be : 6” apart for X0069 & X0070; 13.5” apart for X0071 & X0072; 18.5” apart for X0073 & X0074; Plastic clips should be in line with each other. (See Fig. 2) Fig.2. Plastic clip Dry Wall Screw 3. Secure the plastic clips to the mounting surface with the dry wall screws provided. Make sure the ear’s side of plastic clip facing outside. (See Fig. 2) Ear 4.
PAGE 3
Synchronous control: When more than two lights are connected together in series, you can interact with the motion sensor control on any fixture in the series and the other lights will be controlled synchronously. Function and Operation Choose an option by sliding the switch on the surface of the sensor control. (See Fig.8 ). When the switch is set to “ ”, the sensor is deactivated. When the switch is set to “ ”, the sensor 's active detection range is 4" below the fixture.
PAGE 4
The following spare parts are available if damaged or missing.