Installation Sheet

Die Cast Connector

Dry Wall Screw

Cover

Junction Box

Turn off the power at fuse or circuit box

160120

Installation Steps

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package:

X0045 / X0046

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

1. Find a suitable location to mount the junction box.

The mounting surface should be a minimum of 1/2”

thickness.

2. Once you have determined the position where the

junction box will be mounted, mark the corresponding

knockout closest to your supply wire feed.

CAREFULLY REMOVE THE KNOCKOUT BY

HAMMERING A FLATHEAD SCREWDRIVER OR

PUNCH UNTIL THE SURFACE BREAKS.

Use pliers and bend it back and forth until it snaps

off if necessary. (See Fig.1)

3. Unscrew the set screw from junction box, and then

remove the cover of junction box. (See Fig.2)

4. Attach the die-cast connector (included) by inserting

the threaded end through the knockout. Secure the

die-cast connector to junction box panel by

tightening the 1/2" lock nut. (See Fig.3)

Fig.2

Fig.1

Fig.3

Lock Nut

Die-cast

Connector

Mounting Screw

Set Screw

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS X0045 / X0046 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package: Dry Wall Screw Fig.1 Die Cast Connector Installation Steps Turn off the power at fuse or circuit box 1. Find a suitable location to mount the junction box.
PAGE 2
5. Attach the conduit to the die-cast connector and tighten the mounting screws on the die-cast connector so the conduit is gripped securely. Insert the cable through the die-cast connector with at least 6" of cable that extends past the cabinet junction box panel. (See Fig.4) Fig.4 Mounting Screw 6. Place the junction box to the mounting surface and then secure it to cabinet with two dry wall screws. (See Fig. 5) 7.