Installation Sheet

1. Unscrew the two bolt nuts (D), remove the mounting plate unit (A) from the backplate.

2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the

preinstalled fixture mounting screws if necessary.

Note: Make sure that two fixture mounting screws are lined up horizontally to make the fixture level.

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.

• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.

• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with green ground screw, then

depending on local code, connect it to the house ground wire with the wire connector (C).

Carefully put all of the wires back into the outlet box.

4. Attach the backplate of the fixture to the mounting plate unit (A) by aligning and inserting the two fixture mounting

screws into set holes on backplate, then secure it with two bolt nuts (D).

5. Install bulb (not included). Check relamping label at socket area or packaging for maximum wattage allowed.

6. Unscrew set screws (E) from the glass holder, attach the glass shade onto the glass holder and secure them

with set screws (E).

Turn off the power at fuse or circuit box.

Installation Steps

Turn on the power at fuse or circuit box.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Assembly Kit

6424MM (1 SET)

Glass Shade

9847CG

Mounting Screw (B) Wire Connector (C) Bolt Nut (D)Mounting Plate Unit (A)

Set Screw (E)

210715

A: 16"

B: 5"

C: 6"