Installation Sheet

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

W0394

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Bolt Nut (D)Mounting Plate Unit (A)

Turn off the power at fuse or circuit box

Installation Steps

1. Attach mounting plate unit (A) to the outlet box using two mounting screws (B). Adjust the length of the preinstalled

fixture mounting screws if necessary.

Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.

2. Pull out the wires and ground wire from the outlet box. Make wire connections using the wire connectors (C) as follows:

---Connect the hot wire (black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.

---Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then connect it

to the house ground wire with the wire connectors (C).

Carefully put the wires back into the outlet box.

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Backplate

Bolt Nut (D)

Fixture Ground Wire

Outlet Box

Wire Connector (C)

House Ground Wire

Mounting Plate Unit (A)

Green Ground Screw

Mounting Screw (B)

Fixture Mounting Screw

Max 60W

Medium base bulb

(not included)

Glass Shade

Glass

Holder

210202

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0394 W WARNING: TO TO SHUT SHUT OFF OFF TOAVOID AVOID RISK RISK OF OF ELECTRICAL ELECTRICAL SHOCK, BE SURE TO POWER INSTALLINGOR OR SERVICING THIS FIXTURE. POWERBEFORE WHILE INSTALLING SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Attach the backplate to the mounting plate unit (A) by aligning and inserting the two fixture mounting screws from the mounting plate unit (A) into the open holes on the backplate, then screw it with the two bolt nuts (D). 4. Rotate the glass shade onto the glass holder. Install 4 X 60W medium base bulbs (not included). See relamping label at socket area or packaging for maximum wattage allowed. Turn on the power at fuse or circuit box.