Installation Sheet

170908
Page 2
Turn on the power at fuse or circuit box.
1. Remove and discard the stopper from the
back plate.
2. Thread headless screws through the cross
bar, then secure them with four lock nuts
(two on each side of the cross bar). Adjust
the length of the headless screws if
necessary.
Note: Make sure that the headless screws
are lined up horizontally to make the fixture
level.
3. Unscrew and discard the green grounding
screw from the cross bar.
4. Place the cross bar to a proper position.
a) If the wall material is wood:
Attach the cross bar to the wall, then
secure it with the dry wall screws
b) If the wall material is cement: Mark the
holes where you want to place the
cross bar on the wall. Drill the holes
and insert the anchors into the holes,
then attach the cross bar to the wall,
secure the dry wall screws into the
anchors.
5. Thread plug cord through the pipes,
swivel, threaded pipe, the bottom hole of
the back plate, washer, and hex nut in turn
as shown in Fig.1, then connect the pipes.
6. Secure the assemble pipes to the back
plate by using the washer and hex nut.
7. Thread the plug cord through two holes of the strain relief. Pull the plug cord down until the strain relief touches the
back plate.
Note: Adjust the strain relief can decrease or increase the length of the exposed plug cord.
Turn off the power at fuse or
circuit box.
Option 2: (Plug-in Installation)
Assembly Instructions:
Fig.1
Stopper
Plug Cord
Strain Relief (H)
Pipe
Pipe Strap (N)
Dry Wall Screw (O)
Back Plate
Wire Connector (F)
Holder
Socket
Cross Bar (A)
Headless
Screw (C)
Dry Wall
Screw(O)
Lock Nut (D)
Ball Nut (G)
Bulb Type A Max.60W
(not included)
Shade
Anchor (L)
Swivel (I)
Hex Nut (J)
Washer (K)
Set Screw
Threaded Pipe (M)
Anchor (L)
Socket Ring
Bushing(P)
Plug
Cover
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually bare wire) to the cross bar with the green grounding screw, then connect
it to the house grounding wire with a wire connector. If your outlet box does not have a house grounding wire, then
wrap the fixture grounding wire around the green grounding screw.
Carefully tuck the wires back into the outlet box.
4. Attach the back plate to the cross bar by inserting the headless screws, then secure it with the ball nuts.
5. Attach the shade onto the holder and secure it with the socket ring.
6. Install bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.