Installation Guide

ManualsBrandsVaxcel Lighting ManualsBathroom LightsCarlisle 4 Light 30-1/4" Wide Vanity Light

1. Attach the threaded pipe to the mounting strap, then secure it with a washer and hex nut.

2. Attach the mounting strap to the outlet box by using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually bare wire) to the mounting plate with the green grounding screw. Then connect

it to the house grounding wire with a wire nut. If your outlet box does not have a house grounding wire, then wrap the

fixture grounding wire around the green grounding screw.

Carefully tuck the wires back into the outlet box.

4. Attach the fixture to the mounting strap by inserting the threaded pipe, then secure it with the finial.

Glass Shade

Glass Holder

Socket Ring

Mounting Screw (B)

Fixture Wire

Mounting Strap (A)

Hex Nut (D)

Washer (H)

Fixture Grounding Wire

Back Plate

Green Grounding Screw (E)

Outlet Box

Finial (G)

Bulb Type A15 Max.60W

(not included)

Mounting Strap (A)

Mounting Screw (B)

Green Grounding

Screw (E)

Wire Nut (F)

Finial (G)

141122

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0149

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Assembly Instructions:

Turn off the power at fuse or circuit box.

Hex Nut (D)

Threaded Pipe (C)

Washer (H)

Threaded Pipe (C)

Wire Nut (F)

Summary of content (2 pages)

PAGE 1
W0149 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Attach the glass shades onto the glass holders and secure them with the socket rings. 6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. Turn on the power at the main fuse or circuit breaker box. The following parts are available for re-order if damaged or missing.