Installation Sheet

ManualsBrandsVaxcel Lighting ManualsLightingBlackwell 8" Wide Outdoor Mini Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

1. Attach the mounting strap unit (A) to the outlet box by using

two mounting screws (B).

2. Choose the length of the chain (G) you need,

then weave the fixture wire and the fixture

grounding wire through the chain (G), collar (E)

and canopy (D).

3. Connect one end of the chain (G) with the loop by

using a loop lock (F).

4. Connect the other end of the chain (G) with the

top loop by using another loop lock (F).

5. Unscrew the two set screws and remove the metal frame

from the fixture.

6. Take a glass panel and gently slide it into the metal frame bottom

notch in place, secure it by pressing two clips on top side of the

metal frame. Repeat with the other glass panels. (See Fig.1)

Turn off the power at fuse or circuit

box.

Installation Steps

210311

Glass Panel

Bottom Notch

Fig.1

T0609

Mounting Strap Unit (A) Wire Connector (C)

Collar (E)

Mounting Screw (B)

Canopy (D)

Loop Lock (F)

Chain (G)

Hardware Package(inculded):

WARNING:

TO A L SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Fixture

Glass Panel

Set Screw

Clip

Metal Frame

Outlet Box

Housing Grounding Wire

Wire Connector (C)

Fixture Wire

Fixture Grounding Wire

Mounting Strap Unit (A)

Green Grounding Screw

Mounting Screw (B)

Threaded Pipe

Hex Nut

Washer

Top Loop

Canopy (D)

Loop Lock (F)

Collar (E)

Chain (G)

Loop

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Max.60W

Type T10 Bulb

(not included)

Summary of content (2 pages)

PAGE 1
T0609 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: WARNING: Turn off the power at circuit breaker before installing fixture. TOmain A L SHOCK, BE SURE TO SHUT OFF AVERTISSEMENT: Coupez la source d’alimentation principale au panneau POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
7. Attach the metal frame back to the fixture by aligning holes, secure them with the two set screws. 8. Thread the fixture wire and fixture grounding wire through the mounting strap unit (A). 9. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows: • Connect the smooth wire (marked) from the fixture to the black wire from the power source. • Connect the ridged wire (unmarked) from the fixture to the white wire from the power source.