Installation Sheet

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

T0607 / T0608

Set screw (D) Mounting Screw (B) Wire Connector (C)Mounting Plate Unit (A)

Rubber Pad (E)

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Fixture Grounding Wire

Wire Connector (C)

Mounting Plate Unit (A)

House Grounding Wire

Green Grounding Screw

Outlet Box

Fixture

Fixture Wire

Set Screw (D)

Mounting Screw (B)

Rubber Pad (E)

Glass Panel

Set Screw-a

Metal Frame

Clip

Photocell

Backplate

Max.60W

Type T10 Bulb

(not included)

Glass Panel

Bottom Notch

Fig.1

210312

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0607 / T0608 TOmain AVOIDpower RISK OF SHOCK, BE SURE TO SHUT OFF WARNING: Turn off the at ELECTRICAL circuit breaker before installing fixture. POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Turn off the power at fuse or circuit box Installation Steps 1. Unscrew the two set screws (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate. 2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Note: Make sure that two set holes are lined up horizontally to make the fixture level. 3. Unscrew the two set screws-a, remove the metal frame from the fixture. 4.
PAGE 3
1. Turn off the power at the fuse or circuit box before starting installation. 2. Loosen the wire connector connected with the wires from photocell. (See Fig.2) Note: Do not remove the photocell to prevent water from seeping into the outlet box. 3. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.3) a. The black wire from the fixture to one end of the black pigtail. b. The white wire from the fixture to one end of the white pigtail. c.