Installation Sheet

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Set screw (D) Mounting Screw (B) Wire Connector (C)Mounting Plate (A)

Mounting Hardware

6358MM (1SET)

Turn on the power at fuse or circuit box

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

• Attach the fixture grounding wire (usually green with the insulation or bare wire) to the mounting plate (A)

with green grounding screw. Then, depending on local code, connect it to the house grounding wire with the

wire connector (C).

Carefully put all of the wires back into the outlet box.

4. Attach the backplate of the fixture to the mounting plate (A) by aligning holes, secure the two set screws (D)

from the side hole of the backplate into the hole of the mounting plate (A).

Note: With silicone caulking compound, caulk completely around where the backplate meets with the

wall surface to prevent water from seeping into the outlet box.

5. Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.

6. Attach the glass shade to the lamp holder by aligning solder bumps and turn it clockwise until it is locked in place.

A: 15-1/2"

B: 6-3/4"

C: 7"

Glass Shade

10249CG

210317