Installation Sheet

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

T0603 T0604

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Bolt Nut (D) Rubber Pad (E)Mounting Plate Unit (A)

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Mounting Plate Unit (A)

Fixture Wire

Bottom Arm

Fixture Grounding Wire

Backplate

Glass Shade

Set Screw

CAUTION: Hold glass when securing

or removing arm.

Max.60W Type T10 Bulb

(not included)

Rubber Pad (E)

Bolt Nut (D)

Fixture

Photocell

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

210312

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0603 T0604 W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box. 1. Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate. 2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled headless screws if necessary. Note: Make sure that two headless screws are lined up horizontally to make the fixture level. 3. Unscrew the set screw, remove the bottom arm from the fixture. 4.
PAGE 3
1. Turn off the power at the fuse or circuit box before starting installation. 2. Loosen the wire connector connected with the wires from photocell. (See Fig.1) Note: Do not remove the photocell to prevent water from seeping into the outlet box. 3. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.2) a. The black wire from the fixture to one end of the black pigtail. b. The white wire from the fixture to one end of the white pigtail. c.