Installation Sheet

ManualsBrandsVaxcel Lighting ManualsLightingCoventry 15" Tall Outdoor Wall Sconce

Page 2 / 5

210317

1. Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.

2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the

preinstalled headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally to make the fixture level.

3. Loosen the three set screws and remove the metal ring from the metal frame.

4. Gently place glass shade into the metal frame, then attach the metal ring onto the metal frame by aligning holes, secure

it with the three set screws from the bottom holes of the metal ring into the holes in the bottom of the metal frame.

5. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

• Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate unit (A) with the green

grounding screw. Then, depending on local code, connect it to the house grounding wire with the wire connector (C).

Carefully put all of the wires back into the outlet box.

6. Attach the backplate of the fixture to the mounting plate unit (A) by aligning and inserting the two headless screws into

set screws on the backplate, then secure it with two rubber pads (E) and the two bolt nuts (D).

Note: With silicone caulking compound, caulk completely around where the backplate meets with the wall

surface to prevent water from seeping into the outlet box.

7. Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.

Turn off the power at fuse or circuit box

Turn on the power at fuse or circuit box

Installation Steps

The Position of Control Panel

Step 1: Rotate the sensor lens from left side to right side

to show the adjustable knobs and slide switch.

(See Fig.1)

Step 2: Adjust time

by knobs and choose the mode you want by

slide switch. (See Fig.2 and Fig A).

Step 3: Restore the sensor lens to original position.

(See Fig.3)

low level brightness and sensitivity

Fig.2

View Fig.A

Fig.3

Sensor

Lens

“Time” Knob

“Sens” Knob

Slide Switch

“Low Level” Knob

Time Low Level

Sens

Fig.A

Test

Fig.1

Sensor

Lens