Installation Guide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

T0591

Mounting Plate Unit (A) Wire Connector (C)Mounting Screw (B)

Set screw (D)

Fixture

Socket

Glass Panel

Photocell

Backplate

Fixture Grounding Wire

Wire Connector (C)

Mounting Plate Unit (A)

House Grounding Wire

Green Grounding Screw

Outlet Box

Fixture Wire

Set Screw (D)

Mounting Screw (B)

Max.60W Type

Vintage Bulb

(not included)

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

201013

PAGE 1
T0591 ASSEMBLY AND INSTALLATION INSTRUCTIONS TOmain AVOIDpower RISK OF SHOCK, BE SURE TO SHUT OFF WARNING: Turn off the at ELECTRICAL circuit breaker before installing fixture. POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Fig.1 Bottom Frame Turn off the power at fuse or circuit box Bottom Screw Clip 1. Remove the two set screws (D), the mounting plate unit (A) from the backplate. 2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Note: Make sure that two set holes are lined up horizontally to make the fixture level. Fixture 3. Put the fixture upside down.
PAGE 3
. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.4) a. The black wire from the fixture to one end of the black pigtail. b. The white wire from the fixture to one end of the white pigtail. c. The other end of the black pigtail to the black wire from the power source. d. The other end of the white pigtail to the white wire from the power source. Put all wires back into the back plate of the fixture. Turn on the power at fuse or circuit box.