Installation Guide

Turn off the power at fuse or circuit box
Installation Steps
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Screw (B) Wire Connector (C) End Cap (D)Mounting Strap Unit (A)
Mounting Hardware
6189MM (1SET)
Front Glass Panel
X1
Glass Panel
X2
10133CS
191127
A
B
C
A: 10-1/2”
B: 5-1/2”
C: 4-1/4”
1. Attach the mounting strap unit (A) to the outlet box by using two mounting screws (B).
2. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
• Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap unit (A) with
the green grounding screw. Then, depending on local code connect it to the house grounding wire with the
wire connector (C).
Carefully put all of the wires back into the outlet box.
3. Attach the fixture to the mounting strap unit (A) by inserting the threaded pipe, then secure
it with the end cap (D).
4. Make the top of the fixture upward, gently place three glass panels into the frame, then
press the clips to secure the glass panels and front glass panel.(See Fig.2)
5. Install bulb (not included). Check relamping label at socket area or packaging for maximum
wattage allowed.
6. Attach the door lock secure the fixture.
Clip
Fixture
Fig.2
Turn on the power at fuse or circuit box