Installation Guide

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

191203

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Ball Nut (D) Rubber Pad (E)Mounting Plate Unit (A)

T0548 / T0549

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

Photocell

Backplate

Fixture

Socket

Bolt Nut (D)

Set Screw x 3

Rubber Pad (E)

Glass Shade

Bulb (not included)

Max.60W Type Vintage

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Mounting Plate Unit (A)

Fixture Wire

Fixture Grounding Wire

Set Screw x 3

Fig.1

Glass Shade

Fixture

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0548 / T0549 WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box. 1. Remove the two bolt nuts (D), the two rubber pads (E) and the mounting plate unit (A) from the backplate. 2. Attach the mounting plate unit (A) to the outlet box using two mounting screws (B). Adjust the length of the preinstalled headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally to make the fixture level. 3. Pull out the source wires from the outlet box.
PAGE 3
The following parts are available for re-order if damaged or missing.