Installation Sheet

House Grounding Wire

Green Grounding Screw (E)

Wire Connector (C)

Back Plate

Mounting Screw (B)

Mounting Plate (A)

Outlet Box

Fixture Wire

Set Screw (D)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0397 /T0398 / T0400 / T0401

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

180129

Green Grounding

Screw (E)

Set screw (D)

Mounting Screw (B)

Wire Connector (C)

Mounting Plate (A)

NOTES:

Upper light and lower light options：

1. Option 1: Upper & Lower light accent, the original setting of wall light is the upper and lower light accent.

2. Option 2: Lower light accent only, loosen the wire connectors ( 1 and 2 ). (See Fig. 1) Do not discard the wire

connectors, screw the wire connectors onto the wire from lower light of driver. (See Fig. 2) Wrap all wire connectors

with electrical tape, then tuck all wire connectors into the back plate.

Fig. 1

Upper Light

Fig. 2

Lower Light

THIS SIDE UP

label

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0397 /T0398 / T0400 / T0401 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Mounting Plate (A) Wire Connector (C) Mounting Screw (B) Green Grounding Screw (E) Set screw (D) NOTES: Fig. 2 Fig.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box 1. When mounting to a wall, the “THIS SIDE UP” arrow must point upward and remove the label. 2. Attach the mounting plate to the outlet box by using two mounting screws. 3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire connectors: ---Connect the black wire from the fixture to the black wire from the power source.