Installation Sheet

170803
Turn on the power at fuse or circuit box
Rubber Pad (H)
Cross Bar (A)
Curved Arm Set Screw Washer Lock Nut-2
6. Attach the back plate to the cross bar by inserting two headless screws, and then secure it with two rubber pads and
two ball nuts.
NOTE: With silicone caulking compound, caulk completely around where the back plate meets with the wall
surface to prevent water from seeping into the outlet box.
7. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
A
B
C
A
B
C
Mounting Screw (B)
Wire Nut (F)
Ball Nut (G)
Lock Nut (E)
Headless Screw(D)
Green Grounding
Screw (C)
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5622MM (1 SET)
A: 5" B: 13" C: 6"
T0332
T0331
Glass Panel
9900CS
Mounting Hardware
3098CA