Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0164
141203
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (D)
Canopy (I)
Loop Lock (K)
Chain (L)
Hex Nut (E)
Washer (F)
Threaded Pipe(G)
Top Loop (H)
Collar (J)
1. Attach threaded pipe to the mounting strap, then secure it with a washer
and hex nut.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Place the glass shade into the metal frame carefully, and then secure it by
pressing the clips from the bottom side. (See Fig.1)
4. Secure the top loop to threaded pipe.
5． Connect the chain:
- Determine length of chain needed to achieve desired fixture height. (To remove excess chain section, use pliers
to bend link open.)
- Weave the fixture wires and fixture grounding wire through the chain ,collar and canopy.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box.
Installation Steps
Outlet Box
House Grounding Wire
Wire Nut(D)
Fixture Wire
Fixture Grounding Wire
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Threaded Pipe(G)
Canopy(I)
Top Loop(H)
Hex Nut(E)
Washer(F)
Collar(J)
Loop Lock(K)
Loop Lock(K)
Chain(L)
Loop
Fixture
LED 6W
Metal Frame
Metal Frame
Clip
Glass Shade
Glass Shade
Fig.1
Clips