Installation Guide

ManualsBrandsVaxcel Lighting ManualsLightingMilano Single Light 4" Wide Pendant

200115

1. Unscrew two ball nuts (H), remove mounting strap (A) from canopy.

2. Loosen the plastic headless screw on the canopy by using flat head

screwdriver (I) .

3. Install a bulb on the socket,attach the socket into the glass shade

by inserting the threaded pipe, put the cap through the threaded

pipe and adjust position of it to ensure it set in the center of glass,

then thread the plastic headless screw onto threaded pipe and

fasten by using flat head screwdriver (I).

Caution :Please be careful for installation since the bulb will

be easily damaged if crash the glass shade.

4. Thread the cord through the canopy and strain relief (G).

Measure the desired length of the cord (a) from the canopy

to the glass shade and leave additional 9" cord (b) above

the canopy (include the canopy), and then cut off the

unnecessary cord. (See Fig.1)

5. Adjust strain relief (G) at 9" position from the top of the cord.

6. Mark the 3" cord (c) from the top of the cord (b). Use a knife

to peel off the insulation of the cord (c) carefully to show the

3 inside wires out. (See Fig. 1)

Caution : Cutting too deep may cut off three inside wires

and destroy the insulation surface of the three inside wires.

7. Peel off the 3 wires from the top about 3/8" long (d) to expose

the copper for wiring.

8. Attach the mounting strap

(A)

to outlet box by using two mounting

screws

(B)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

P0327

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Fig.1

Installation Steps

Canopy

Ball Nut (H)

Cord (a)

Fixture Wire

Hex Nut

Medium Base Bulb

Max.60W (not included)

Socket

Strain Relief (G)

Mounting Strap (A)

Green Ground Screw (C)

Lock Nut (D)

Mounting Screw (B)

Wire Connector (F)

Fixture Mounting Screw (E)

Outlet Box

c(3")

d(3/8")

b(9")

Plastic Headless

Screw

Plastic Headless

Screw

Cap

Mounting Screw (B)

Wire Connector (F)

Strain Relief (G)

Mounting Strap (A)

Fixture Mounting Screw (E)

Green Ground Screw (C)

Lock Nut (D)

Ball Nut (H)

Flat Head Screwdriver (I)

Glass Shade

Threaded Pipe

Flat Head

Screwdriver (I)

Summary of content (2 pages)

PAGE 1
P0327 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
9. Pull out the source wires from the outlet box. Make wire connections using wire connectors (F) as follows: a. Connect the black wire marked "L" from the fixture to the black wire from the power source. b. Connect the white wire marked "N" from the fixture to the white wire from the power source. c. Connect the copper wire or green wire marked " " from the fixture to the mounting strap (A) by securing it with the green ground screw.