Installation Guide

191226

Turn on the power at fuse or circuit box.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Assembly Kit

6183MM (1 SET)

Glass Panel

10128CS

5130CD

A x 4 B x 4 C x 4

B / C

Fig.1

Fig.2

9. Pull out the outlet wires and house ground wire from the outlet box.

Make wire connections using the wire connectors (E):

---The smooth wire (marked) from the fixture to the black wire from the power source.

---The ridged wire (unmarked) from the fixture to the white wire from the power source.

---Attach the fixture ground wire to the mounting strap (A) with the green ground

screw.Then connect it to the house ground wire with a wire connector (E).

Carefully put the wires back into the outlet box.

10. Attach the canopy (F) to the mounting strap (A) .

11. Install the crystal drops A , crystal drops B and crystal drops C as shown in diagram.

(See Fig.1 and Fig.2)

12. Attach 4pcs glass panels to fixture and lock it with set screws 1 for upper side and set

screws 2 for bottom side.

13. Install the bulb (not included). Check relamping label at socket area or packaging

for maximum wattage allowed .

14. Attach the canopy (F) onto the outlet and tighten it with two ball nuts (I).

Mounting Strap (A)

Wire Connector (E)Lock Nut (D)

Mounting Screw (B)

Fixture Mounting

Screw (C)

Canopy (F)

Loop Lock (G)

Chain (H)

Ball Nut (I)

A: 15"

B: 10"

C: 10"

A x 4

A B C

B x 4

C x 4