Installation Guide

Turn on the power at fuse or circuit box
Fig. 1
Outlet Box
Support Brace
Canopy
Coupling Kit
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
6159MM (1 SET)
12”Rod
3216RD (3PCS)
6”Rod
3217RD(1PC)
3”Rod
3218RD (1PC)
Glass Shade
10114MG (1PC)
Mounting Strap (A)
Mounting Screw (B) Wire Connector (C)
Fixture Mounting Screw (D)
Lock Nut (E) Ball Nut (F)
4. Rod connections:
a. Thread the fixture wire from the fixture through the lower rod, then secure the lower rod onto fixture using the
threaded pipe.
b. Thread the fixture wire through the middle rod, then secure the middle rod onto the lower rod using the
threaded pipe.
c. Thread the fixture wire through the upper rod, then secure the upper rod onto the middle rod using the
threaded pipe.
d. Thread the fixture wire through the canopy, then secure the canopy onto the upper rod using the threaded pipe.
Note: Length adjustable from 24-3/8” to 66-3/8”. Use fewer rods if shorter length is desired.
5. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture ground wire to the mounting strap (A) with the green ground screw, then connect it to
the house ground wire with a wire connector (C).
Carefully put the wires back into the outlet box.
6. Attach the fixture canopy to the mounting strap (A) by inserting the fixture mounting screws (D), then
secure it with two ball nuts (F).
7. Remove three fuse bolt nuts from three studs, thread the studs through the holes of the rings on the edge of glass shade,
then secure them with fuse bolt nuts.
Note: When installing the ring, the ring must be placed as per
the tag arrow points upward, do not reverse it.
8. Install bulbs (not included).
Check relamping label at socket area or packaging for maximum
wattage allowed.
9. Angled mounting recommended for a vaulted or angled ceiling.
(See Fig.1)
191128