Installation Guide

ManualsBrandsVaxcel Lighting ManualsLightingHayes 4 Light 16" Wide Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

191105

1. Attach threaded pipe (E) to the mounting strap (A),

then secure it with a washer (G) and hex nut (F).

2. Attach the mounting strap (A) to the outlet box by

using two mounting screws (B).

3. Secure the top loop (I) to threaded pipe (E).

4. Choose the length of the chain (L) you need,

then weave the fixture wire and the fixture

ground wire through the chain (L), collar (J)

and canopy (H).

5. Connect one end of the chain (L) with the loop by using a loop lock (K).

6. Connect the other end of the chain (L) with the top loop (I) by using another loop lock (K).

7. Thread the fixture wire and fixture ground wire through the top loop (I), threaded pipe (E) and

mounting strap (A).

Turn off the power at fuse or circuit

box.

Installation Steps

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0310

Mounting Strap (A)

Wire Connector (D)

Collar (J)

Washer (G)

Mounting Screw (B) Green Ground

Screw (C)

Hex Nut (F)

Canopy (H) Top Loop (I)

Threaded Pipe (E)

Loop Lock (K)

Chain (L)

Hardware Package(inculded):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Fixture

Candelabra Base Bulb

Max.60W (not included)

Outlet Box

Housing Ground Wire

Wire Connector (D)

Fixture Wire

Fixture Ground Wire

Mounting Strap (A)

Green Ground Screw (C)

Mounting Screw (B)

Threaded Pipe (E)

Hex Nut (F)

Washer (G)

Top Loop (I)

Canopy (H)

Loop Lock (K)

Collar (J)

Chain (L)

Loop

Summary of content (2 pages)

PAGE 1
P0310 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
8. Pull out the outlet wires and house ground wire from the outlet box. Make wire connections using the wire connectors (D): ---The smooth wire (marked) from the fixture to the black wire from the power source. ---The ridged wire (unmarked) from the fixture to the white wire from the power source. ---Attach the fixture ground wire to the mounting strap (A) with the green ground screw (C). Then connect it to the house ground wire with a wire connector (D). Carefully put the wires back into the outlet box. 9.