Installation Guide

141120
A:35-3/4"
B: 21"
C:15"
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5223MM (1 SET) for P0140
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (D)
Canopy (I)
Loop Lock (K)
Chain (L)
Hex Nut (E)
Washer (F)
Threaded Pipe(G)
Top Loop (H)
Collar (J)
3. Secure the top loop to the threaded pipe.
4. Connect the chain:
- Determine length of chain needed to achieve desired fixture height. (To remove excess chain section, use pliers to
bend link open.)
- Weave the fixture wires through the chain, collar, and canopy.
5. Connect one end of the chain to the loop using a loop lock.
6. Connect the other end of the chain to the top loop using the other loop lock.
7. Thread the fixture wire and fixture grounding wire through the top loop, threaded pipe and mounting strap.
8. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to the house
grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting strap: insert the top loop through hole, then secure it by tightening collar.
10. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Mounting Strap (A)