Installation Sheet

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
1. Attach the mounting strap unit (A) to the outlet box by using
two mounting screws (B).
2. Choose the length of the chain (G) you need,
then weave the fixture wire and the fixture
ground wire through the chain (G), collar (E)
and canopy (D).
3. Connect one end of the chain (G) with the loop by
using a loop lock (F).
4. Connect the other end of the chain (G) with the
top loop by using another loop lock (F).
5. Thread the fixture wire and fixture ground wire
through the top loop, threaded pipe and
mounting strap unit (A).
6.
Hook the lamp with three tubes and then adjust
the angle, finally lock the loop with loop lock (F).
Turn off the power at fuse or circuit
box.
Installation Steps
210322
H0261
Mounting Strap Unit (A) Wire Connector (C)
Collar (E)
Mounting Screw (B)
Canopy (D)
Loop Lock (F)
Chain (G)
Hardware Package(inculded):
WARNING:
TO
L SHOCK, BE SURE TO SHUT OFF
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ
AND SAVE THESE INSTRUCTIONS.
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Loop
Outlet Box
House Ground Wire
Wire Connector (C)
Fixture Wire
Fixture Ground Wire
Mounting Strap Unit (A)
Green Ground Screw
Mounting Screw (B)
Threaded Pipe
Hex Nut
Washer
Top Loop
Canopy (D）
Loop Lock (F)
Loop Lock (F)
Collar (E)
Chain (G)
Candelabra Base Bulb
Max.60W
(not included)
Tube