Installation Guide

191231

Turn on the power at fuse or circuit box.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Assembly Kit

6184MM (1 SET)

Glass Panel

10130CS

5132CD

A x 2 B x 6 C x 4

D x 4 E x 4 F x 4 G x 4

Wire Connector (B)Mounting Screw (A)

Loop Lock (C)

Chain (D) Ball Nut (E)

Dry Wall Screw (F) Anchor (G)

7. Pull out the outlet wires and house ground wire from the outlet box.

Make wire connections using the wire connectors (B):

---The smooth wire (marked) from the fixture to the black wire from the power source.

---The ridged wire (unmarked) from the fixture to the white wire from the power source.

---Attach the fixture ground wire to the mounting back plate with the green ground screw.Then connect it to the

house ground wire with a wire connector (B).

Carefully put the wires back into the outlet box.

8. Install the crystal drops A , crystal drops B, crystal

drops C, crystal drops D,crystal drops E, crystal

drops F and crystal drops G as shown in diagram.

(See Fig.1)

9. Attach 10pcs glass panels to fixture and lock it with

set screws 1 for upper side and set screws 2 for

bottom side.

10. Install the bulbs (not included). Check relamping label at socket area or packaging for maximum wattage allowed .

11. Attach the canopy onto the mounting back plate and tighten it with four ball nuts (E).

A: 20-1/4"

B: 36-5/8"

C: 10-3/4"

Fig.1

D B

B C