Installation Sheet

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
SAFETY INFORMATION
Vintage Bulb
Max.60W
(not included)
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box.
1. Attach the mounting unit(AA) to
outlet box with mounting
screws(BB).
Note: The depth of threaded
pipe on the mounting unit may
need to be adjusted to properly
fit the canopy.
2
3
BB
AA
1
1
HH
A
B
4. - Determine length of chain(FF)
needed to achieve desired fixture
height. (To remove excess chain
section, use pliers to bend link
open.)
- Weave the fixture wires and
fixture grounding wire through
the chain(FF), the collar(EE) and
the canopy(DD).
- Connect the chain(FF) to the
loop(A) and the top loop on the
mounting unit(AA) using the two
loop locks(GG).
- Thread the fixture wires and
fixture grounding wire through the center of the
mounting unit(AA).
2. Secure the loop(A) onto the
fixture(B).
3. Install five Vintage Bulbs(HH)
Max.60W (not included).
EE
GG
GG
FF
A
DD
AA
4
AA
5. Connect the smooth wire to black
wire(power), the ribbed wire to white
wire(neutral) with the wire connector
(CC) provided. Connect the copper
wire on the light fixture to the
mounting unit(AA) by securing it with
the preinstalled grounding screw,
and then connect it to the house
grounding wire with the wire connector(CC).
Tuck all the wires into outlet box.
DD
CC
5
180801