Installation Sheet

Page 1 of 3

Chain

Loop Lock

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

H0207

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read and save these instructions.

Important to Know

1. Read all instructions carefully before installation and operation.

2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified

electrician.

3. Before installation, shut off power at the main fuse or circuit breaker box. Be aware that simply turning off the

wall switch is not sufficient to prevent an electrical shock.

4. This fixture requires a 120 VAC, 60 Hz power source.

5. Do not attempt to take the lantern apart; there are no serviceable parts inside.

Maximum Wattage: 60W Incandescent Bulb

Work Temperature: - 4°F~104°F

Mounting Unit

Mounting Screw

Wire Connector

Canopy

Collar

HARDWARE CONTENTS Note: Hardware not shown actual size.

180801

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS H0207 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions. Important to Know 1. Read all instructions carefully before installation and operation. 2.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING ● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). ● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
ASSEMBLY INSTRUCTIONS (continued) 6. Attach the canopy(DD) to the mounting unit(AA), and then secure it by tightening the collar(EE). 6 DD Turn on the power at fuse or circuit box. AA EE The following parts are available for re-order if damaged or missing. Call toll free at 800-482-9235.