Installation Guide

8. Connect the chain:
- Determine length of chain needed to achieve desired fixture height. (To remove excess chain section, use pliers
to bend link open.)
- Weave the fixture wires and fixture grounding wire through the chain, collar and canopy.
9. Connect one end of the chain to the loop using a loop lock.
10. Connect the other end of the chain to top loop by using the other loop lock.
11. Thread the fixture wire and fixture grounding wire through the top loop, threaded pipe and mounting strap.
12. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to the
house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
13. Attach the canopy to the mounting strap by inserting the top loop, then secure it with the collar.
14. Attach the glass shades to the glass holders, then secure them with socket rings.
15. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
141127
Turn on the power at fuse or circuit box.
box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
5241MM for H0129
5242MM for H0130
Glass Shade
9684FO
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Nut (E)
Canopy (G)
Top Loop (H)
Collar (I)
Threaded Pipe (F)
Washer (J)
Loop Lock (K)
Chain (L)
A: 36"
B: 40-3/4"