Installation Sheet

Attach the glass shade to the light kit
by aligning studs and slots, and then turn
it clockwise until it is locked in place.
Glass Shade
Slot
Stud
Light Kit
Fig.16
Install the battery (9V, included) into the transmitter.
Fig.17
Turn ON the electric circuit at the main fuse
or circuit breaker box.
Fig.18
LED
INDICATOR
* Press "HI" button to turn on the fan at high speed.
* Press "MED" button to turn the fan in medium speed.
* Press "LOW" button to turn the fan in low speed.
* Press "FAN OFF" button to turn off the fan.
* Press "REVERSE" button to set direction of fan rotation.
The fan speed will slow down until the fan is turned off and it will restart by spinning in the
reverse direction and resume the previously selected speed setting.
* Press "LIGHT ON /OFF" button to turn on or turn off the light.
* Press and hold the "DIMMER" button to dim or brighten lights to the desired level and
release, and the brightness level will be memorized.Turn on the light again, then fan
light will restore to the brightness level which was dimmed last time.
* Press "DIMMER" button to change color temperature of fan light, there are a total of
5 levels of color changing from 2700K,3000K,3500K,4000K to 5000K.
Note:
1. This remote controller has a memory function setting. The fan will operate at the same
speed and the fan light will stay at the same brightness as the last time the power supply
was turned off.
2. Compatible wall switch model NO.:LUTRON / SKYLAPR / SFSQ-LFH-WH.
a. This wall switch only can turn on or turn off the light, no dimming function.
b. This LED module has memory function setting. The fan light will stay at the same
brightness and temperature as the last time of remote control setting.
c. Before remove the receiver of remote control,please setting your favorite brightness
and temperature. Install Without Remote Controller Fig.21.
d. The direction of fan rotation can’t be set without remote controller.
e. The fan speed will be stay at high speed after remove the remote controller.
Please use wall control to adjust the speed which you need.
Operating transmitter:
Set the code:
Within the 10 seconds time frame after the main power is turned on, press and hold FAN
OFF button more than 3 seconds. The LED indicator of transmitter will begin to flash.
Once set code successful, the fan turned off and the light turned on.
Note: Included transmitter matched with receiver was the factory default Settings, no need to
set the code again. Go through these setup steps if you found your transmitter can’t match
with receiver.
PAGE: 8 / 11
210811