Installation Sheet

Slide the canopy up to ceiling and over
the two canopy screws on hanger bracket.
Rotate canopy clockwise, next, while holding
the canopy with one hand, slide the decorative
cap over the screws and rotate clockwise until tight.
Note: Adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
Remove one screw and loosen another two screws from the bottom of the
housing first, next thread the capacitor through the hole of connect plate of light
kit, then push the connect plate of light kit upwards until the housing screws insert
into the key hole slots of connect plate of light kit then rotate the connect plate of
light kit until it’s fixed on the housing. Secure the connect plate of light kit to
housing with previous screw which was removed and tighten the other two housing
screws. Finally, remove the white paper on capacitor and then stick the capacitor
on the connect plate of light kit.
Hang the safety cable into the safety cable hook. (See Fig.12)
Fig.13
Canopy Screw
Hanger Bracket
Canopy
Decorative Cap
Remove three screws from connect plate of light kit first. Then connect
the white (neutral) wire from the fan light to white (neutral) wire from
connect plate of fan light with a wire connector; connect the black (hot)
wire from fan light to blue (hot) wire from connect plate of light kit with
a wire connector. Carefully put the wires into the connect plate of light kit,
and then secure the light kit into connect plate of light kit with previous
three connect plate of light kit screws.
0
Connect Plate of
Light Kit
Connect Plate
Screw
Capacitor
Housing
Fig.14
Connect Plate
Screws
Connect Plate
of Light Kit
Light Kit with
LED Module
Capacitor
Capacitor
White Paper
Fig.14-1 Fig.14-2
PAGE: 7 / 11
Fig.15
Fig.12
Safety Cable Hook
Safety
Cable
210811