Installation Sheet

Install LED bulbs (included).
See relamping label at socket area
or packaging for maximum wattage
allowed.
Attach the glass shade, rubber pad and metal
pad upward through the threaded pipe and
secture with hex nut. Then attach the end cap
to the glass shade and secure it with finial.
Take care to align the holes on the glass shade
and the end cap, so the pull chains pass through
and move freely.
Fig.19
Turn on the electric power at the main fuseor circuit breaker box.
The slide switch on switch box sets direction
of fan rotation. Select the desired direction of
fan rotation.
Push the slide switch down for " Forward" and
up for "Reverse".
Note: Wait for fan to stop before reversing
the direction of blade rotation.
Install two pull chains and drops onto the pull
chains located in the switch box and light kit.
The pull chain controls the fan speed as follows:
1 pull – High, 2 pull – Medium, 3 pull – Low,
Glass Shade
Fan Light
Rubber Pad
Hex Nut
Metal Pad
Decorative Cup
Finial
Fig.17
Forward
Reverse
Fan Speed
Pull Chain
Fan Light Pull Chain
Reverse Switch
Fig.18-a
Forward
Reverse
Side Switch
Fig.18-b
Fig.16
Remove the finial ,end cap,
hex nut, metal pad and rubber
pad from glass shade first.
Adjust the glass shade and
cap direction, make sure that
the hole of glass shade and
the knob of the switch box are
lined up perpendicularly.
Adjust the fan light direction,
make sure that the chain does
not touch the sockets or light
bulbs.
Fig.15
2-9W E26 A19 LED
Bulbs (included)
E26 A19 bulb Max.9W
PAGE: 8 / 9
and 4 pull – Off.
To turn the light kit “ON” or “OFF”, pull the chain that is attached to the light kit.
Caution:
1. If you install a wall control for this fan, pull the pull chains to “high
speed” of the fan motor and “on” of the fan light.
2. Compatible wall switch model No.: Menards SKU# 3632615 / 3635815.
210413