Installation Sheet

Mount each blade bracket to fan blade
using three blade screws and washers.
Make sure the wires of the fan light
in the switch box are capped with
wire connector. Secure the switch
box cover into switch box with the
switch box cover screws.
To install the fan light, skip this step
and proceed to Fig.13.
Remove screws and washers from
motor first and then secure the
blade brackets to the motor with
motor screws and washers.
Remove screws from fan light first,
then connect the white (neutral) wire
from the fan light to white (neutral) wire
from switch box with a wire connector,
connect the black (hot) wire from fan
light to blue (hot) wire from switch box
with a wire connector.
Carefully put the wires into the switch
box, then attach the fan light into the
switch box with the fan light screws.
Washer
Hex Nut
Fig.8
Decorative
Housing
Mounting Bracket
Screw
Lock Washer
Attach the mounting bar to mounting
bracket with metal washers and hex
nut by hand and then free your hands
to secure the hex nut by spanner.
The decorative housing has two mating slots
and two mating holes. Position both slots on
the decorative housing directly under and in
line with two screws and washers in the
mounting bracket. Unscrew two lock washers
and two lock screws from mounting bracket.
Lift the decorative housing, allowing the left
two screws and washers to slide into the
mating slots. Rotate the decorative housing
clockwise until both screws from the mounting
bracket drop into the slot recesses. Tighten
screws securely. Install the unscrewed two
screws and washers into the mating holes
of the mounting bracket and tighten to secure
the decorative housing to the mounting bracket.
Blade Screw
Washer
Blade Bracket
Blade
Fig.10
Washer
Blade Bracket
Motor Screw
Fig.11
Fig.12
Switch Box Cover
Switch Box Cover Screw
Pull Chain
Fig.13
Wire
Connector
Pull Chain
Switch Box
Socket
Fan Light
Pull Chain
Fig.14
Mounting Bracket
Mounting
Bar
PAGE: 7 / 9
Fig.9
Hang the safety cable into the safety cable hook.
210413