Installation Sheet

ManualsBrandsVaxcel Lighting ManualsCeiling FansHumboldt 21" 3 Blade Indoor Ceiling Fan with A Wire Mesh Shade

PAGE: 5 / 10

Installation Steps :

INSTALLATION INSTRUCTIONS

IMPORTANT:

BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION N THE SEPARATE

SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN

DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

SAVE ALL INSTRUCTIONS.

NOTE: The fan weight is 15.21 lbs (6.9 kg). Be sure the outlet box you are using is securely attached to the building

structure and can support the full weight of the fan. Failure to do so can result in serious injury.

Hanger Pin

Lock Pin

Remove the Lock Pin and take off

the Hanger Pin.

Fig.3

Loosen the collar screws part way.

Insert the Downrod into the Collar.

Slide Hanger Pin through holes of

Collar and Downrod.

Insert and tighten the two Collar

Screws. Slide Lock Pin into Hanger

Pin until it locks into position.

Slide canopy, canopy cover and

downrod stand cover onto downrod,

as shown; then thread motor wires

Hang fan on hanger bracket, and rotate the downrod until the chip on

the hanger bracket snaps into the slot on the hanger ball.

Note: For slope ceiling installation, make sure the slot of hanger

ball and the chip of hanger bracket are toward the floor.

Slot

Chip

Hanger Bracket

Fig.7

Fig.5

Hanger Pin

Motor Wires

Fig.6

Lock Pin

Collar

Screws

Fig.1

Turn OFF the electric circuit at the

main fuse or circuit breaker box.

Fig.4

Motor Wires

Collar

Downrod

Canopy

Canopy Cover

Downrod Stand

Cover

through downrod.

Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure

the outlet box is securely installed so that it will be able to support at least the

fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and

washer, and make sure the safety cable hook is covered by the fan canopy.

WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR

FAN SUPPORT"!

Washer

Safety Cable Hook

Dry Wall Screw

Ceiling

Hanger Bracket

Ceiling Joist

Wood Member

(2" x 4" Approx.)

Junction Box

Fig.5.Fig.2.

Ceiling

Hanger Bracket

Ceiling Joist

Wood Member

(2" x 4" Approx.)

Junction Box

210827