Installation Sheet

Secure blade holders to the motor
with motor screws.
NOTE: Before installing blade
holders to the motor, please
remove the plastic inserts.
Remove the 4 hanger bracket screws
and washers from the hanger bracket.
Attach the canopy to the hanger
bracket, then secure it with four
screws and washers.
Thread the blade screws through the
rubber washer、blade holder. And
into the decorative cap. Tighten all blade
screws securely. Repeat to other blade.
Fig.11
Blade
Blade Holder
Blade Screw
Plastic Insert
Fig.12
Motor Screw
Blade Holder
Screw
Hanger Bracket
Washer
Canopy
Fig.10
Blue
Green (Ground)
Fig.8
Make wire connections:
1). The white motor wire to the white wire from the outlet box with a wire nut.
2). The black motor wire and blue wire to the black (hot) wire from the outlet box
with a wire nut.
3). The ground wire from the outlet box to the ground wire from the motor
with a wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded wires on one side of the outlet box and the ungrounded wires on the
other side of the outlet box.
*** After the connections have been made, the wires should be turned upward and
pushed carefully up into the outlet box.
Decorative Cap
Rubber washer
Fig.13
Switch Box Screw
Switch Box Cover
Assembly without fan light
Make sure the wires of the fan light in
the switch box are capped with wire
nuts. Secure the switch box cover with
the switch box screws.
Note: To install the fan light, skip this
step and proceed to Fig.14.
Fan Light Installation:
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current
demand. Turn off power to the fan and replace the light bulbs with lower wattage bulbs.Turn on
power to the fan, using the pull chain, wall switch, or remote control (whichever is installed on the
particular fan).
F A N C O
140820
Hang the safety cable into the safety cable hook.
Fig. 9
Safety Cable Hook
Safety
Cable
PAGE: 6 / 8