Installation Sheet

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0255
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
210309
Mounting Screw (B) Wire Connector (C) Bolt Nut (D)Mounting Strap Unit (A)
Outlet Box
House Ground Wire
Wire connector (E)
Mounting Strap (A)
Fixture Mounting Screw (D)
Green Ground Screw (C)
Mounting Screw (B)
Canopy
Bolt Nut (D)
Bolt Nut (D)
Rod
Metal Bar
Metal Bar
Metal Ring
Interior Glass
Swivel
Max 60W
Medium base bulb
(not included)
1. Tighten the rod to the swivel.
2. Attach the two assembly screws to the mounting
strap unit (A), and screw them in 2 to 3 turns.
3. Attach the mounting strap unit (A) to the outlet box
using two mounting screws (B).
4. Pull out the source wires from the outlet box.
Make wire connections using wire connectors (C)
as follows:
---Connect the hot wire (black insulation)
from the fixture to the black wire from
the power source.
---Connect the neutral wire (white insulation)
from the fixture to the white wire from the
power source.
---Attach the fixture ground wire
(bare wire) to the mounting strap unit (A)
with the green ground screw, and then
connect it to the house ground wire with
the wire connector (C) .
Carefully put the wires back into the outlet box.
5.
Attach the canopy to the mounting strap unit
(A)by inserting two assembly mounting screws,
and then secure it with two bolt nuts (D) .
6. Put the interior glass in the metal ring, tighten with metal bar and then secure it with two bolt nuts (D).
7. Install 3 X 60W medium base bulbs (not included).
See relamping label at socket area or packaging for maximum wattage allowed.