Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
190424
C0225
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Installation Steps
1. Secure the fixture and finial onto the frame.
2. Thread two fixture mounting screws (D) through the mounting strap (A),
and then secure with two lock nuts (E). Adjust the length of the fixture
mounting screws (D) if necessary .
3. Attach the mounting strap (A) to the outlet box by using two mounting
screws (B).
4. Pull out the source wires from the outlet box. Make wire connections
using wire connectors (C) as follows:
---Connect the hot wire (black insulation) from the fixture to
the black wire from the power source.
---Connect the neutral wire (white insulation) from the fixture
to the white wire from the power source.
---Attach the fixture ground wire (green insulation or bare
wire) to the mounting strap with the green ground screw. Then
connect it to the house ground wire with the wire connector (C).
Carefully put the wires back into the outlet box.
5. Attach the canopy kit to the mounting strap (A) by
inserting the fixture mounting screws (D), and then
secure it with two ball nuts (F) .
6. Install three bulbs (not included).
Check relamping label at socket area or packaging
for maximum allowed wattage.
Turn on the power at fuse or circuit box
Outlet Box
House Ground Wire
Mounting Strap (A)
Lock Nut (E)
Green Ground Screw
Mounting Screw (B)
Fixture Ground Wire
Fixture Mounting Screw (D)
Wire Connector (C)
Fixture Wire
Canopy Kit
Ball Nut (F)
Finial
Fixture
Frame
Mounting Strap (A) Fixture Mounting Screw (D)Wire
Connector (C)
Lock Nut (E) Ball Nut (F)
Mounting Screw (B)
Bulb Type B Max.60W
(not included)