Installation Sheet

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

181115

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0209

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

GU10 LED Max.7W (G)

(included)

Swivel

Light Head

Stem

Plastic Anchor (D)

Ceiling Support

Stem Bushing (I)

Wood Screw (E)

Canopy

Outlet Box

Set Screw

Mounting Screw (B)

Wire Connector (C)

Cross Bar (A)

Green Grounding

Screw

Cupule (F)

GU10 LED Bulb

Max.7W X6 (G)

Cross Bar (A)

Mounting Screw (B)

Wire Connector (C)

Plastic Anchor(D)

Wood Screw (E)

Turn off the power at fuse or circuit box

Installation Steps

1. Attach the cross bar (A) to the outlet box by using two mounting screws (B).

2. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections by using the wire

connector (C) as follows:

--- Connect the black (hot) wire from the fixture to the black (hot) wire from the power source.

--- Connect the white (neutral) wire from the fixture to the white (neutral) wire from the power source.

--- Attach the fixture grounding wire to the cross bar (A) with the green grounding screw. Then connect it to the house

grounding wire with a wire connector (C).

Carefully put the wires back into the outlet box.

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0209 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Cross Bar (A) Wood Screw (E) Mounting Screw (B) Wire Connector (C) Plastic Anchor(D) GU10 LED Bulb Max.
PAGE 2
3. Attach the canopy to the cross bar (A) by aligning holes, secure the set screws from the side hole of the canopy into the hole in the side of the cross bar (A). 4. Make two desired positions and drill holes on the ceiling for stem on the track. 5. Attach two plastic anchor (D) to the drilled positions, then attach wood screw (E) thread the ceiling support stem bushing (H) to the plastic anchor (D) on the ceiling and twist the wood screw (E) to lock pins in place. 6.