Installation Sheet

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or
death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means, do
not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
SAFETY INFORMATION
180801
A
EE
DD
AA
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box.
1. Attach mounting unit(AA) to outlet
box by using two mounting
screws(BB).
Note: The depth of threaded
pipe on the mounting unit may
need to be adjusted to properly
fit the fixture.
3
4
AA
BB
1
AA
CC
2
2. Connect fixture black wire to
house black wire and fixture
white wire to house white wire
using wire connectors(CC)
provided. Connect the copper wire
or green / yellow wire on the light
fixture to the mounting unit(AA) by
securing it with the preinstalled
grounding screw, and then connect
it to the house grounding wire with
the wire connector(CC).
Tuck all the wires into outlet box.
3. Attach the fixture(A) to the mounting
unit(AA) by inserting preinstalled
threaded pipe into the center hole
of the fixture(A), and then secure it
with a finial(DD).
4. Install two Vintage Bulbs(EE)
Max.60W (not included)
Turn on the power at fuse or circuit
box.
Vintage Bulb
Max.60W
(not included)