Installation Sheet

Turn off the power at fuse or circuit box
Mounting Screw (A) Wire Connector (B)
1. Remove the metal ring and plastic shade from
ceiling pan by unscrewing the cap nuts.
Installation Steps
Outlet Box
House Grounding Wire
Wire Connector(B)
Ceiling Pan
LED Module
Threaded Stud
Protective Cover
Plastic Shade
Metal Ring
Cap Nut
Mounting Screw(A)
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0150/C0151/0152/C0153
Hardware Package (included):
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
171023
2. Attach the two mounting screws to the outlet box,
and screw them in 2 to 3 turns.
3. Pull out the source wires from the outlet box. Make
wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from
the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
---Attach the fixture grounding wire (usually green
insulation or bare wire) to the mounting strap
with the green grounding screw. Then connect
it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the outlet box by inserting
two mounting screw heads into the key holes,and
rotate the ceiling pan until it is locked in place,then
secure the mounting screws tightly.
5. Lay the plastic shade into metal ring, attach them up
to the ceiling pan by inserting the threaded studs, then
secure them with cap nuts.
Turn on the power at fuse or circuit box