Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0076
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
141205
Mounting Strap (A)
Green Grounding
Screw (C)
Long Screw(D)
Mounting Screw (B)
Wire Nut (E)
1. Attach the two long screws to the holes on the mounting
strap, thread them in part way: 2 to 3 turns only.
2. Attach the mounting strap to the outlet box by using two
mounting screws.
3. Pull out the source wires from the outlet box. Make
wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from
the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green
grounding screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes, and rotate the ceiling pan
until it locks in place. Then secure the long screws tightly. (See Fig.1)
5. Screw the threaded pipe into the coupling, then secure it with a washer and a hex nut.
NOTE:Depth of threaded pipe may need to be adjusted to properly fit glass shade, decorative cup and finial.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
7. Attach the glass shade to the ceiling pan by inserting the threaded pipe, then secure it with a metal pad and hex nut.
8. Slip the decorative cup up through the threaded pipe, secure it with the finial.
Turn on the power at fuse or circuit box.
Outlet Box
House Grounding Wire
Fixture Grounding Wire
Wire Nut(E)
Long Screw(D)
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Fig.1
Screw
Key Hole Slot
Metal Pad(K)
Hex Nut(H)
Decorative Cup(G)
Finial(F)
Glass Shade
Hex Nut(H)
Threaded Pipe(J)
Washer(H)
Coupling
Ceiling Pan
Bulb Type A Max.60W
(not included)
Installation Steps
Hex Nut (H)
Washer (I)
Threaded pipe (J)
Metal Pad (K)
Finial (F)
Decorative Cup (G)