Owner`s manual

The first step in an Ethernet boot is to gather the information from your
system that you need in the Ethernet boot.
Use the SHOW ETHERNET command to find the address of your
system on the Ethernet and write it down. You load this address into
the executor system’s volatile database in the next step (Section 4.9.2).
The system reports the hardware Ethernet address for the DEMNA.
The DEMNA is at XMI node E.
The system also reports the FDDI hardware address for the DEMFA
adapter.
The system manager of the target system and the system manager of the
executor system assign a node name and a network address for the target
machine. In Example 4–4 the assigned node name is TARGET, and the
node network address is 9.961.
Booting 4–23