Owner`s manual

8. * Passing control to transfer address
J.2 Local Disk Boot Messages
1. [Start Boot]
?002E Specified node is not an I/O adapter
?0100 Specified adapter failed self-test
?010A Illegal adapter specified for disk boot
2. * Initializing adapter
?0119 Failure to initialize specified adapter
3. * Specified adapter initialized successfully
4. * Connecting to boot disk or
* Reading bootblock from disk
?0102 Controller error detected—aborting
?0103 Drive error detected—aborting
?010E Specified unit offline — No media mounted or disabled via
RUN/STOP switch setting
?0114 Serious exception reported—aborting
?0116 Specified unit is inoperative
?0117 Specified unit offline
?0118 Specified unit offline—Unit unknown, online to another
controller or port disabled via A,B switches
5. * Passing control to transfer address
J.3 Local Tape Boot Messages
1. [Start boot]
?002E Specified node is not an I/O adapter
?0100 Specified adapter failed self-test
?010C Illegal adapter specified for tape use
2. * Initializing adapter
?0119 Failure to initialize specified adapter
3. * Specified adapter initialized successfully
4. * Connecting to tape or
* Reading bootblock from tape or
J–2 VAX 6000 Series Owner’s Manual