Owner`s manual

Appendix J

Boot Status and Error Messages

(Models 500 and 600)

This appendix lists status and error messages for Ethernet boots, local disk

and tape boots, and cluster boots (Models 500 and 600). Status messages

are shown in the order they would appear after the boot command is issued.

Listed after each status message are the error messages that could appear

during each boot subprocess.

J.1 Ethernet Boot Messages

1. [Start boot]

?002E Speciﬁed node is not an I/O adapter

?0100 Speciﬁed adapter failed self-test

?010B Illegal adapter speciﬁed for NI boot

2. * Initializing adapter

?0119 Failure to initialize speciﬁed adapter

3. * Speciﬁed adapter initialized successfully

4. * "Request Program" MOP message sent—waiting for service from

remote node

?0113 No trafﬁc was detected on the Ethernet—aborting boot

procedure

?0115 Aborting boot process—adapter failed attempting to execute

port command

?011F Aborting boot process—adapter failed attempting to execute

boot command

5. * Still waiting for assistance—reissuing "Request Program" message

6. * Remote service link established

7. * Reading boot image from remote node

?010F Failed to receive image from remote server

Boot Status and Error Messages (Models 500 and 600) J–1