Owner`s manual

Table I–2 (Cont.): Model 300 Standard Console Error Mes-
sages
Error Message Meaning
?52 EEPROM header is corrupted. The EEPROM header has been cor-
rupted. The EEPROM must be re-
stored from the TK tape drive.
?53 EEPROM revision mismatch.
Secondary processor has revision x.y/x.y.
A secondary processor has a differ-
ent revision of EEPROM or has a dif-
ferent set of EEPROM patches in-
stalled.
?54 Failed to locate EEPROM area. The EEPROM did not contain a set of
data required by the console. The EEP-
ROM may be corrupted.
?55 Console parameters on secondary proces-
sor do not match primary.
Console parameters do not match on the
primary and secondary processors.
?56 EEPROM area checksum error. A portion of the EEPROM is corrupted.
It may be necessary to reload the EEP-
ROM from the TK tape drive.
?57 Saved boot specifications on secondary pro-
cessor do not match primary.
Saved boot specifications do not match
on the primary and secondary proces-
sors.
?58 Invalid unit number. A BOOT or SET BOOT command speci-
fies a unit number that is not a valid hex-
adecimal number between 0 and FF.
?59 System serial number mismatch.
Secondary processor has xxxxxxxx.
The indicated serial number of a sec-
ondary processor does not match the pri-
mary.
?5A Unknown type of boot device. The console program does not have a boot
primitive to support the specified type
of device or the device could not be ac-
cessed to determine its type.
?5B No HELP is available. The HELP command is not supported
when the console language is set to Inter-
national.
?5C No such boot spec found. The specified saved boot specification was
not found in the EEPROM.
?5D Saved boot spec table full. The maximum number of saved boot spec-
ifications has already been stored.
Console Error Messages for Model 300 I–7