Owner`s manual

Table H–2 (Cont.): Standard Console Error Messages (Model 400

and Higher)

Error Message Meaning

?00A0 Initializing system.

The console is resetting the system in re-

sponse to a BOOT command.

?00A1 Now updating the EEPROM of node n

The console is updating the EEPROM.

?00A6 Console halting after unexpected ma-

chine check or exception.

The console executed a Halt instruc-

tion to reset the console state after pro-

cessing an unexpected machine check.

?00A7 RCSR <WD> is set. Local CCA must be

built.

When the <WD> bit is set, writes to mem-

ory are disabled. The Model 400 pro-

cessor must then build a CCA in lo-

cal memory. Main memory cannot be writ-

ten to or accessedwith interlocked instruc-

tions.

?00A8 Bootstrap failed due to previous error.

The previous attempt to bootstrap the sys-

tem failed.

?00A9 Restart failed due to previous error.

The previous attempt to restart the sys-

tem failed.

Node n: ?xxxx Error message ?xxxx was generated on sec-

ondary processor n and was passed

to the primary processor to be dis-

played.

No numbered preﬁx appears with these messages in English language mode. These num-

bers are used for these messages in International mode.

Console Error Messages (Model 400 and Higher) H–11