Owner`s manual

Table H–2 (Cont.): Standard Console Error Messages (Model 400
and Higher)
Error Message Meaning
?0067 Read of EEPROM image from tape failed. The EEPROM image was not success-
fully read from tape.
?0068 Validation of local EEPROM failed. For a PATCH EEPROM operation, the
EEPROM must first contain a valid im-
age before it can be patched. For a RE-
STORE EEPROM operation, the im-
age was written back to EEPROM
but could not be read back success-
fully.
?0069 EEPROM not changed. The EEPROM contents were not changed.
?006A EEPROM changed successfully. The EEPROM contents were success-
fully patched or restored.
?006B Error changing EEPROM. An error occurred in writing to the EEP-
ROM. The EEPROM contents may be cor-
rupted.
?006C EEPROM saved to tape successfully. The EEPROM contents were success-
fully written to the TK tape.
?006D EEPROM not saved to tape. The EEPROM contents were not com-
pletely written to the TK tape.
?006E EEPROM Revision = x.xx/y.yy. The EEPROM contents are at revi-
sion x.xx with revision y.yy patches.
?006F Major revision mismatch between tape
image and EEPROM.
The major revision of tape and EEP-
ROM do not match. The requested opera-
tion cannot be performed.
?0070 Tape image Revision = x.xx/y.yy. The EEPROM image on the TK tape is
at revision x.xx with revision y.yy patches.
?0073 System serial number updated. The EEPROM has been updated with the
correct system serial number.
?0074 System serial number not updated. The EEPROM has not been changed.
?0075 /CONSOLE_LIMIT value too small for
proper operation. Value ignored.
No change has been made.
?0076 Error writing to tape. Tape may be
write-locked.
Tape has not been written. Check to see
if tape is write-locked.
Console Error Messages (Model 400 and Higher) H–9