Owner`s manual

Table H–2 (Cont.): Standard Console Error Messages (Model 400
and Higher)
Error Message Meaning
?004C Invalid node for Z command. The target of a Z command must be a CPU
or an I/O adapter and must not be the pri-
mary processor.
?004D Invalid node for new primary. The SET CPU command failed when at-
tempting to make the specified node the
primary processor.
?004E Specified node is not a processor. The specifiednode isnot a processor, as re-
quired by the command.
?004F System serial number has not been
initialized.
No CPU in the system contains a valid
system serial number.
?0050 System serial number not initialized on
primary processor.
The primary processor has an uninitial-
ized system serial number. All other pro-
cessors in the system contain a valid se-
rial number.
?0051 Secondary processor returned bad
response message.
A secondary processor returned an un-
intelligible response to a request made
by the console on the primary proces-
sor.
?0052 ROM revision mismatch. Secondary
processor has revision x.xx.
The revision of console ROM of a sec-
ondary processor does not match that of
the primary.
?0053 EEPROM header is corrupted. The EEPROM header has been cor-
rupted. The EEPROM must be re-
stored from the TK tape drive.
?0054 EEPROM revision mismatch.
Secondary processor has revision x.xx/y.yy.
A secondary processor has a differ-
ent revision of EEPROM or has a dif-
ferent set of EEPROM patches in-
stalled.
?0055 Failed to locate EEPROM area. The EEPROM did not contain a set of
data required by the console. The EEP-
ROM may be corrupted.
?0056 Console parameters on secondary proces-
sor do not match primary.
The console parameters are not the same
for all processors .
?0057 EEPROM area checksum error. A portion of the EEPROM is corrupted.
It may be necessary to reload the EEP-
ROM from the TK tape drive.
Console Error Messages (Model 400 and Higher) H–7