Owner`s manual

Example E–1: Updating EEPROM Contents
>>> BOOT /XMI:n /R5:10 DUxx
[the VAX Diagnostic Supervisor banner appears]
DS> LOAD EVUCA
DS> ATTACH KA66A HUB KA0 1
DS> ATTACH KA66A HUB KA1 2
DS> SELECT ALL
DS> SET TRACE
DS> START
.. Program: EVUCA - VAX 6000 EEPROM Update Utility, revision 2.0, 4
tests, at 00:05:57.61.
Testing: _KA0 _KA1
Node 02, booting.
Test 2: Load data from media
Data file to be loaded? <EXUCA.BIN>
! Model 600
Searching...
Load complete.
Update rev: 0200
Test 3: Determine typecodes updated
Test 4: Update EEPROM data
Creating new eeprom in memory.
Writing to EEPROM.
Verifying EEPROM on node 01
EEPROM rev: 0200
Verification complete on node 01
Secondaries are being updated, please wait maximum of 20 seconds.
Secondary CPU 02 Done.
Verification complete.
The primary was successfully updated.
Secondary CPU 02, was successfully updated.
.. End of run, 0 errors detected, pass count is 1,
time is 1-NOV-1991 00:07:05.94
DS> EXIT
>>>
EVUCA Program E–3