Owner`s manual

The self-test printout in Figure 6–2 reflects the system configuration
listed in Table 6–1. Each numbered item in the example is explained in
Section 6.3 through Section 6.7. These sections assume the same system
configuration, when discussing the printout information.
See Section 6.8 for a description of self-test results when a VAXBI adapter
is part of the system configuration. A sample self-test display with a vector
processor is shown in Section 5.27.
Table 6–1: System Configuration for Sample Self-Test
Module
XMI Node
Number Module Type
KA66A 1 Processor; disabled from being boot processor.
KA66A 2 Processor; fails first level of self-test.
KA66A 3 Processor; boot processor after first level of self-test, fails ex-
tended test.
KA66A 4 Processor; operating as boot processor.
MS65A 7 Memory (64 Mbytes); interleaved with memory at node 8 by a
SET MEMORY console command.
MS65A 8 Memory (64 Mbytes); interleaved with memory at node 7 by a
SET MEMORY console command.
MS65A 9 Memory (64 Mbytes); interleaved with memory at node A by
a SET MEMORY console command.
MS65A A Memory (64 Mbytes); interleaved with memory at node 9 by a
SET MEMORY console command.
CIXCD D I/O adapter; passes self-test.
DEMNA E I/O adapter; passes self-test.
System Self-Test and Troubleshooting 6–5